Monday 28 September 2009 7:13:45 am
I managed to enable debugging by changing the settings/site.ini. I now have both inline and debugging to file. This shows some warnings on each page, but only about missing translations. I also only have warnings and notices about the same in var/log/warnings.log and notices.log, and a debug.log but no error.log On the final page after the setup i get:
Fatal error: eZ Publish did not finish its request
The execution of eZ Publish was abruptly ended, the debug output is present below.
eZ debug
Timing: Sep 28 2009 16:11:02
Script start
Timing: Sep 28 2009 16:11:02
Module start 'setup'
Debug: ezi18n Sep 28 2009 16:11:02
No translation for file(translation.ts) in context(lib/template): 'The maximum nesting level of %max has been reached. The execution is stopped to avoid infinite recursion.' with comment()
Timing points:
Checkpoint Elapsed Rel. Elapsed Memory Rel. Memory
Script start 0.0000 sec 0.0379 sec 2,959.8594 KB 2,536.1250 KB
Module start 'setup' 0.0379 sec 5,495.9844 KB
Total runtime: 0.1756 sec
Peak memory usage: 10,940.0703 KB
Time accumulators:
Accumulator Elapsed Percent Count Average
ini_load
Load cache 0.0043 sec 2.0736% 7 0.0006 sec
TS translator
TS init 0.0062 sec 2.9894% 1 0.0062 sec
TS cache load 0.0004 sec 0.1779% 1 0.0004 sec
TS context load 0.0000 sec 0.0227% 1 0.0000 sec
General
String conversion 0.0000 sec 0.0160% 2 0.0000 sec
Total script time: 0.2068 sec
The "No translation for file(translation.ts) etc.." is not the issue I think after reading http://issues.ez.no/14982. The "Script Start" and "Module start 'setup'" do not end, but no clues for the cause.
|