Installation problems - setup wizard doens't load

Installation problems - setup wizard doens't load

Tuesday 14 August 2007 7:21:14 am - 3 replies

Author Message

André R.

Tuesday 14 August 2007 8:44:16 am

On all versions downloaded from svn you need to set 'CheckValidity=true' in site.ini.

eZ Online Editor 5: http://projects.ez.no/ezoe || eZJSCore (Ajax): http://projects.ez.no/ezjscore || eZ Publish EE http://ez.no/eZPublish/eZ-Publish-Enterprise-Subscription
@: http://twitter.com/andrerom

Daniel Mandl

Thursday 16 August 2007 1:46:05 pm

Ok, just changed it - but when I click on "Next" to start the setup routine I get the following:

---

Fatal error: eZ publish did not finish its request

The execution of eZ publish was abruptly ended, the debug output is present below.

---

Unfortunately I don't find any helpful solutions for this problem on the internet and now I'm not able to come back to the setup dialogue...
Moreover I don't get any debug message - there's only a white screen and the error message.

Any suggestions anyone ? =)

André R.

Thursday 16 August 2007 3:05:46 pm

search for 'DebugOutput' in site.ini and enable it.

eZ Online Editor 5: http://projects.ez.no/ezoe || eZJSCore (Ajax): http://projects.ez.no/ezjscore || eZ Publish EE http://ez.no/eZPublish/eZ-Publish-Enterprise-Subscription
@: http://twitter.com/andrerom

You must be logged in to post messages in this topic!

Powered by eZ Publish™ CMS Open Source Web Content Management. Copyright © 1999-2014 eZ Systems AS (except where otherwise noted). All rights reserved.